Timer Function; Open Window Function - Mellerware Cuddly! Manual Del Usuario

MODIFICATION OF
PROGRAM 3 (P3)
Display must show P3 to proceed
–
on the modifi cation.
Press the Press the button for 3 seconds. button for 3 seconds.
–
will appear on the screen. Press will appear on the screen. Press
+/- to change the day of the week
you want to modify (d1-d7).
Press Press to confi rm and the time to confi rm and the time
–
will appear on the display. Press +/-
to select the time you want to set.
Press to select the heating
Press to select the heating
–
mode you want for the selected
time (comfort mode time (comfort mode
mode mode or anti-freeze mode or anti-freeze mode
[nothing appears]).
Repeat this operation until all
–
hours and every day of the week
are completed.

TIMER FUNCTION

The operating time of the
–
appliance can be controlled.
Press Press once and the display once and the display
–
will show "0H". Press +/- to select
the hours (0-9h). Wait 3 seconds to
confi rm the operation.
The programmed time or time
–
remaining will appear on the screen.

OPEN WINDOW FUNCTION

Press the and
Press the Press the and and
–
time. time. will appear on the screen. will appear on the screen.
After a few seconds the appliance
–
will return to show the temperature/
timer that was previously.
When the appliance is heating up,
–
if the room temperature drops by
2˚C in 2 minutes, this function will
be activated and the appliance
will stop heating.
To exit the window open mode, To exit the window open mode,
–
press the press the
To deactivate window open mode,
–
press press press
will appear on the screen.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE
Turn the appliance off by pressing
–
the
the
Unplug the appliance from
–
, ECO , ECO the mains.
Clean the appliance.
–
SAFETY THERMAL PROTECTOR
The appliance has a safety device,
–
which protects the appliance
from overheating.
When the appliance switches itself
–
on and off repeatedly, for reasons
other than the thermostat control,
check to ensure that there are no
obstacles that impede correct air
entry or expulsion.
If the appliance turns itself off and
–
does not switch itself on again,
disconnect it from the mains
supply, and wait for approximately
15 minutes before reconnecting.
at the same If the machine does not start again
at the same at the same
–
seek authorised technical assistance.
Cleaning
Disconnect the appliance from the
–
mains and allow it to cool before
undertaking any cleaning task.
button. button.
and and and at the same time. at the same time. at the same time.
button.
button.
EN