Tabla de contenido
Publicidad
TROUBLESHOOTING
FAULT
Unit will not work at all
Unit will not work when in normal
operation
Sensing range too short
Lamp on all the time
Lamp false triggers
Cannot operate Test Mode
Cannot switch off Test Mode
If Normal Mode lamp stays on
for more than 1 minute
POSSIBLE CAUSE
approach into detection bands is incorrect
sensitivity of the PIR sensor
power-up before trying to activate
SOLUTION
change the angle of approach
lantern off
of power-up
approximately 1 minute after the last signal
the PIR receives
Publicidad
Tabla de contenido
