Publicidad
Idiomas disponibles
Idiomas disponibles
107 "L" WORKSTATION STACK-ON UNIT
Illustration 4
Door
Illustration 5
Mounting
plate
Door
Hinge
Mounting
plate
Detail A
242-7418C
SIDE 2 OF 4 (2/05)
Hinge
mounting
hole
Hinge
Hinge slot
Mounting
screw
Mounting screw
Detail B
7. Refer to Illustration 4. Locate hinge mounting holes on
Hinge
rear of door. Lay door, with hinge mounting holes up,
on cardboard or a carpeted surface.
Use the rubber mallet to install two hinges (from hard-
ware pack) onto door as shown. Align hinges with
hinge mounting holes and carefully tap hinges into
place.
Repeat this procedure for remaining door.
8. Refer to Illustration 5. Attach door, with hinges, to
stack-on.
Refer to Detail A. Insert mounting screw on mounting
plate into hinge slot.
Refer to Detail B. Slide hinge rearward until mounting
screw is at the front of hinge slot.
Use the Phillips screwdriver to tighten mounting
screw.
Repeat this procedure for remaining door.
Publicidad
