Publicidad
Idiomas disponibles
Idiomas disponibles
107 "L" WORKSTATION STACK-ON UNIT
Illustration 9
Stack-on unit
Main unit (desk,
credenza, or
corner unit)
Main Unit Positioning
Illustration 10
Mounting tape
Return unit
242-7418C
SIDE 4 OF 4 (2/05)
Main Unit Attachment:
1. Refer to Illustration 9. Once return unit attachment is
/
"
5
8
Mounting tape used to secure stack-on unit is extremely
sensitive and is designed to be a permanent installation.
Attempting to remove stack-on unit will cause severe
damage to surface of main unit.
2. Refer to Illustration 10. Lift one end of stack-on unit up
3. While stack-on unit is raised, unroll and attach adhesive
4. Once mounting tape is attached to stack-on end panel,
Stack-on unit
Do not lean on, bump, or load storage shelf of this
stack-on unit for a period of 12 hours minimum after
the mounting tape has been in contact with main
unit. Do not use unit without anchoring to the "L"
workstation (grommet or mounting tape attach-
ment). Failure to follow this warning can cause the
stack-on unit to tip and fall, resulting in severe injury
Approx. 3"
to yourself or others.
Main unit
complete, align stack-on unit as shown. Place masking
tape on top of main unit to mark end panel position.
IMPORTANT
approximately 3". Be especially careful not to apply any
pressure which may cause the opposite end of stack-on
unit to slip off return.
side of mounting tape to bottom edge of stack-on unit
end panel.
remove protective cover from mounting tape. While
maintaining alignment, carefully lower stack-on unit and
realign end panel with masking tape.
WARNING
Publicidad
