HH TESSEN Serie Manual Del Usuario página 13

SUSPENSION
Tessen cabinets are fitted with M10 flying points for installation and suspended use.
Note that suspension or 'flying' of cabinets should be performed only by properly qualified persons, in
compliance with all local laws and using approved hardware.
If you are not qualified, leave it to somebody who is. Failure to do so could result in serious injury or death!
The rigging or suspended mounting of these speakers can expose members of the public to serious health risks or even
death. Under no circumstances attempt to rig, suspend or otherwise mount this system unless you are fully qualified and
certified to do so by relevant local, state and national authorities. All relevant safety regulations must be followed. If
you are not properly qualified or do not know of pertinent regulations, consult qualified personnel for advice and
assistance.
1 1
Remove the 3x M10 x 35mm travel bolts and store for future use. Remove the 3x M10 x 35mm travel bolts and store for future use.
1 1
2 2
Replace with a suitable M10 eye bolt. Ensure thread is fully engaged into insert Replace with a suitable M10 eye bolt. Ensure thread is fully engaged into insert
Note that eye bolts for flying systems must be cast, Note that eye bolts for flying systems must be cast,
shouldered fittings rated for the purpose. shouldered fittings rated for the purpose.
Forged steel eye bolts of the type typically available Forged steel eye bolts of the type typically available
from DIY suppliers are NOT suitable and should from DIY suppliers are NOT suitable and should
not be used under any circumstances. not be used under any circumstances.
All suspension cables, shackles and other mounting All suspension cables, shackles and other mounting
hardware must be properly secured to the eye hardware must be properly secured to the eye
bolts and be capable of exceeding max load. bolts and be capable of exceeding max load.
Do not fly multiple cabinets together, each must be Do not fly multiple cabinets together, each must be
flown on their own. flown on their own.
30mm min thread length 30mm min thread length
WWW.HHELECTRONICS.COM
13