General Instructions - HH TESSEN Serie Manual Del Usuario

Tabla de contenido

Publicidad

GENERAL INSTRUCTIONS

Thank you for purchasing an HH Passive Full Range Inclosure.
The Tessen series are professional specification cabinets designed to give exceptional dynamics, clarity and projection in all applications from
clubs to large venues.
In order to take full advantage of it and enjoy long and trouble-free performance, please read this owner's manual carefully, and keep it in a safe
place for future reference.
1) Read Instructions carefully before installing or operating this product.
2) Retain these instructions.
3) Comply with warnings: All warnings and instructions for these products should be adhered to.
4) Unpacking: Please retain the packing carton and liners in case the unit should need to be returned at any time.
5) Amplifier connection. In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your sound system.
With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc. BEFORE turning on your power
amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers.
By turning on your power amplifier LAST and making sure its level control is set to minimum, any transients from other equipment will not reach your
loudspeakers.
Wait until all system parts have stabilised, usually takes a couple of seconds.
Similarly when turning off your system, always turn down the level controls on your power amplifier and then turn off its power before turning off
other equipment.
6) Cables- never use shielded or microphone cables for any speaker connections as this will not be substantial enough to handle the amplifier load
and could cause damage to your complete system.
7) Rigging or suspended mounting. The cabinets feature built in flying points fitted with M10 travel bolts, these bolts must be removed
and replaced with the correct type of Eyebolts before any suspended installation is carried out.
The rigging or suspended mounting of these speakers can expose members of the public to serious health risks or even death. Under no
circumstances attempt to rig, suspend or otherwise mount this system unless you are fully qualified and certified to do so by relevant local,
state and national authorities. All relevant safety regulations must be followed. If you are not properly qualified or do not know of
pertinent regulations, consult qualified personnel for advice and assistance.
When mounted o
n a proprietary
used higher than 1.5 metres, without extra support.
8) Exposure to extremely high noise levels may cause permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing
loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time.
The U.S. Government's Occupational Safety and Health Administration (OSHA) has specified the permissible noise level exposure in the chart
opposite.
According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Earplugs or
protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent
permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous
exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing
high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in
operation.
9) Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
FCC COMPLIANCY STATEMENT
his device complies with Part 15 of the FCC rules Operation is subject to the following two conditions:
1)
This device may not cause harmful interference
2)
This device must accept any interference received, that may cause undesired operation.
Warning: Changes or modification to the equipment not approved by
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by
one or more of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
--------------------------------------------------------------------------------
This product conforms to the requirements of the following European Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage (2014/35/EU), EMC (2014/30/EU),
RoHS (2011/65/EU), ErP (2009/125/EU).
---------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal household waste to
landfill sites. It must be taken to an approved recycling centre according to the recommendations of the WEEE (Waste Electrical and Electronic
Equipment) directive applicable in your country.
------------------------------------------------------------------
http://support.hhelectronics.com/approvals
2
tripod pole stand ensure the system is fully stable and can not fall over. We do not recommend pole stands to be
WWW.HHELECTRONICS.COM
HH Electronics Ltd.
can void the user's authority to use the equipment.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tnp-1201Tnp-1501Tnp-2151Tnp-1800s

Tabla de contenido