Reverberi M9004 Libreta Uso Y Manutencion página 5

Manuale del d'uso ed installazione – Reverprint M9004
M9004 (GB)
The printer is automatically powered when the main switch of the
autoclave is turned on and the green led marked with the word "POWER"
lights up.
The printer is ready for printing and will activate whenever a sterilizing
cycle is carried out.
The printer will contain the following data:
Name of the cycle
Sterilizing time
Sterilizing temperature
Progressive cycle number
After this, the real pressure and temperature values will be printed at intervals
of 1 minute
End (end of the cycle)
Date
Time
Total length of the cycle
The led marked with the word "ERROR" will come on if the printer
operates in a faulty way.
An example of a correct print-out is given below.
Make sure that there is always paper in the printer by pressing the two tabs
marked by the arrows and by opening the door as shown in the pictures. The
roll of thermal paper (code 3667) must be inserted in the direction shown in
the picture. Make sure that at least 2 cm of paper have been fed out of the
printer before closing the flap.
As soon as the flap has closed, check that the two tabs with the arrows have
snapped into place as this denotes that the flap has been closed properly.
The key with the word "FEED" advances the paper.
Del 03-01-2007 - C:\Users\bertanil.REVERBERISRL\Desktop\M9004.doc
Pag. 5 di 7