Batteries Installation; Securing Your Child; Maintenance And Care - KIKKA BOO FELICE Instrucciones De Uso

WARNINGS
• This product is suitable for use by babies and kids from newborn to a maximum weight of 9 kg.
• Never leave the child unattended!
• Always use the restraint system!
• Do not place the product on uneven surface! It is absolutely forbidden to use the high chair on raised surfaces above the ground,
surfaces like table, sofa and e.t.c. or near to stairs !
• Toy bar is an additional article! Keep removed toy bar on a safety place! Never use the toy bar to carry the reclined cradle!
• Never use on any elevated surface, since child's movement may cause the product to slide or tip over. Use only on oor.
• Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause su ocation in soft surfaces.
• Never use as a carrier or lift while child is seated!
• To avoid injuries, make sure that the child is away during the folding or unfolding of the product!
• Do not let the child play with the product!
• For domestic use only !
• Regularly check for loose parts! Make routine inspection, regularly maintain, clean and/or wash the article!
• Do not use this product once your child can sit up unaided or weighs more than 9 kg.
• Put the rocker on horizontal and even surfaces.
• On adjusting the backrest you must be sure that the mechanism is well locked in the chosen position.
• Do not leave the article near a switched on fan, heat sources, sharp objects and water containers.
• This article does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
• Do not use accessories or replacement parts other than those approved by the manufacturer.
• Adult assembly is required.
I. PARTS
1. Seat pad 2. Seat tube 3. Screw 4. Left frame 5. Base frame tube 6. Toy bar with toys 7. Right frame 8. Seat tube

BATTERIES INSTALLATION

Hint: We recommend using an alkaline battery for longer battery life.
Loosen the screw in the battery compartment door. Remove the battery compartment door. Insert four "AA" (LR6) 1,5v alkaline battery
into the battery compartment. Replace the battery compartment door and tighten the screw. It this product begins to operate
erratically, you may need to reset the electronics. Slide the power switch o and then back on.
II. ASSEMBLING
1/2. Open the supporting arm of the vertical bases.
3. Insert the vertical bases into the feet tube until you hear a click.
4/5/6/7/8. Place the seat suspension tubes on the axes of the vertical bases. Insert the seat cover. Place the fasteners.
9/12. Install the toy bar on the seat group in the direction of the arrows.
10/11. Install the batteries.
III. SECURING YOUR CHILD
WARNING : Always use the restraint system !
1. Place your child into the seat. Position the restraint pad between your child's legs. Fasten the waist belts to each side of the restraint
pad. Make sure you hear a "Click"on both sides. Check to be sure the restraint system is securely attached by pulling it away from your
child. The restraint system should remain attached. Tighten each waist belt so that the restraint system is snug against your child.
2. Adjusting the length of the belts: Adjust the waist belts with pressing of the button and sliding of the buckle and the shoulder belts
with sliding of the buckle/
IV. USE
1. Recline the seat as pushing the buttons on the side of the seat and rotating up or down.
2. Locking mechanism: To use as a xed seat, press the lock button.
3. Folding: 1. Fold the seat; 2. Stand on front of one foot and press the folding buttons on both sides simultaneously and fold. Repeat the
procedure for the other foot; 3. Fix the snap fastener of the seat.
V. MAINTENANCE AND CARE
1. Wipe clean. Dry naturally. Do not use bleach.
2. The frame, toy bar and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not use harsh or abrasive
cleaners. Rinse clean with water to remove residue. Do not immerse the frame or the toys.
ENGLISH