Kalorik USK STP 20159 Instrucciones página 2

ASSEMBLING THE STAND
To setup the Iron Press Stand correctly
refer to the following instructions:
1. Remove the stand from the carton
and carefully dispose of the
packaging material.
2. Place the stand in the upright
1
position with the feet on the floor.
Open the legs of the stand so that the
unit can stand freely (see Fig. 1).
3. Swing the iron press base plate (a)
over and connect the support leg to
the plate through the opening slit (see
Fig. 2). Lock the support leg into
position with lever (b) (see Fig. 3).
2
4. Take the wire clothes rack and
connect to the legs of the base as
shown (Fig. 4).
5. Take the iron press and sit in place
on the stand plate. Pass one end of
the Velcro strap through the unit in
between the upper and lower arms as
shown (Fig 5). Secure tightly to the
other strap.
3
NOTE: This stand is to be used with the
steam press USK STP 1.
4
5
2
USK STP 20159 STAND - 070502