Mellerware ROBOT 800 Manual De Instrucciones página 4

3.2.2. Simply plug the hand-held stick blender into
the power outlet and select your desired speed.
3.2.3. Place stick blender shaft into the measuring
beaker.
3.2.4. Lower the hand-held stick blender into food
and press the switch (A)
800
3.2.5. To stop the hand-held blender, release the
switch (A)
800
3.3 Instructions for the whisk
(Max operation time cannot exceed 1 minute, and 1
minute rest time)
3.3.1. To assemble the whisk with the motor unit,
place the whisk into the motor making sure it locks
securely. (Fig 2)
Fig 2
3.3.2. Connect the power. To avoid splattering,
insert the whisk into the food before turning on the
power.
3.4.3. Press switch (A) to start whisking.
800
85800_IM.indd 4
Switch A
Switch B
Switch A
Switch B
800
Switch A
Switch B
3.3.4. To disassemble, disconnect from the power
source, and remove the whisk by pulling it out of the
motor housing.
3.4 Instructions for the processor bowl
(Max operation time cannot exceed 15 seconds and
2 minute rest time)
3.4.1. Place the processor bowl on a clean, level
surface.
3.4.2. Assemble the stainless steel blade into the
processor bowl.
3.4.3. Place food into the processor bowl.
3.4.4. Note: remove the bones from meat, cut into
small pieces, then place into bowl, the max quantity
of ingredients can't exceed 350g.
3.4.5. Attach the Lid onto the processor bowl and
turn it until it locks into position
3.4.6. Insert the top part of the blender into the hole
of the procesor lid
3.4.7. Plug the stick blender into the power source
3.4.8.Select your desired speed and push switch(A)
800
3.4.9. To stop the appliance release the switch(A) at
the top of the motor unit.
800
Caution: To reduce the risk of injury, never place the
chopping blade on the base without first putting the
bowl properly in place. Be sure the processor lid is
securely locked in place before operating appliance.
3.5 Instructions for the slicing/shredding blades:
(Max operation time cannot exceed 15 seconds and
2 minute rest time)
3.5.1. Place the processor bowl on a clean, level
surface.
3.5.2. Assemble the desired slicing/shredding blade
into the blade holder
3.5.3. Assemble the blade holder into the processor
bowl.
Switch A
Switch B
Switch A
Switch B
2017/12/18 11:05:59 AM