Classic Accessories OVER DRIVE Guia De Inicio Rapido

Instructions: Deluxe Bike Cover
WARNING!
When transporting your bike(s) with
the cover on, be sure the back zipper
is zipped all the way up with the
rip-and-grip strap fastened—the
cover could blow off and cause
injury to others.
CAUTION
Improper installation and/or covering
more than three bikes can cause
damage to your cover and/or vehicle.
For use on rear hitch mount, bike
racks and tracks.
Installation
1. For Bike Racks: The cover has an
EasyOn ™ split back for fast fitting
around your bike rack arms. Locate
the separating zipper and
rip-and-grip strap. This side faces
the vehicle. For tray-style Bike
Racks: simply place the cover over
your bikes.
2. Find the "CLASSIC" logo on your
bike cover–this is the front of your
cover. Drape your cover over your
bike(s). Now pull the cover down
80-111-011001-00
12cR55_15441
over your bike(s) making sure that
the bike(s) are covered.
3. Close the separating zipper in the
back and secure the zipper with the
rip-and-grip strap.
4. There are D-rings along the bottom
hem for additional securing of the
cover. Attach enclosed rope to the
D-rings and tighten as needed to
secure cover. Be sure your cover is on
tight so that wind cannot blow it off.
Use and Storage
Never store a wet cover as the cover
can be damaged by mildew. Allow
cover to dry before storing.
Care
Spot clean with water, a mild soap
and a sponge. Don't use abrasive
cleaners or brushes.
CLASSIC ACCESSORIES, INC.
KENT, WA USA 98032 ©2012
c l a s s i c a c c e s s o r i e s . c o m
mild soap do not
pack wet
line dry no bleach
water do not iron
resistant
no tools
required