Classic Accessories OVER DRIVE PolyPro 3 Manual De Instrucciones

Instructions: PolyPro 3
WARNING!
Installation is best done with two people.
Never install on a windy day or when your
trailer roof is slippery. Please take care
when you are on a ladder or the roof.
CAUTION
Installation and removal is safer and easier
when done by two people. Please consult
your RV owners manual.
Tools Needed:
• Scissors
• Matches or lighter (optional)
• Screwdriver (usually Phillips head) for
roof antennas
Installation
1. Cover or tape any sharp edges on your RV
that could wear against your RV cover. Be
sure to lower any roof antennas.
2. Unroll the cover next to your trailer. The
Classic logo on your cover should be to the
front of your RV and facing the outside. Unzip
the passenger side and back panels.
3. On smaller trailers your cover can be
installed with ladders or by pulling it over the
sides with tie ropes. (Be sure not to snag the
cover on the top).
On larger trailers it's easiest to install your
cover from the roof. Carefully climb up on the
roof pulling the cover front with you. Lower
the front of your cover down over the front of
your trailer then carefully move toward the
back pulling the cover and letting it fall down
the sides of your trailer.
Climb down the rear ladder and locate the
ladder cap. (The cap helps keep the top of
the ladder from stressing the cover). Fit it
over the ladder top and attach it to the rungs
with the hook and loop straps. Now pull the
back end of the cover down the back of the
trailer.
4. Zip all the panels closed on your cover
then pull the elasticized corners down over
both bumpers of the trailer.
5. Tie an end of the supplied rope onto one
of the D-rings along the bottom hem. Put a
small rock in the provided toss bag, close
12cR55_12857
73163, 73263, 73363, 73463, 73563, 73663, 73763, 73863
Deluxe Travel Trailer Cover
™
the top and tie the free
end of the rope to
the bag
D-ring.
Now toss
the bag
and rope
under your
trailer to
the D-ring
on the
opposite
side.
Take the rope off
the bag and, allowing
enough to make a knot, cut
it off and tie it to the D-ring. Repeat with the
remaining D-rings.
To keep the rope ends from fraying you
can carefully melt the ends with a match or
lighter.
6. Adjust the strap length on the white
tension panels across the front and back
to fit your trailer. Don't over tighten—the
straps should be snug, not drum tight.
To attach the straps into the side-release
buckles just insert the clip into the buckle.
To release the buckle press the buttons
on both sides and pull the clip out of the
buckle.
Use and Storage
Your cover can be unzipped for access to
the passenger side and rear. The panels
can be rolled up and held in place with the
hook and loop straps toward the top of each
panel.
A handy storage bag is provided. To fit it
in the bag fold your cover and roll the cover
tightly rather than stuffing it. Never store
a wet cover in the storage bag or confined
area as the cover can be damaged by
mildew.
Care
Spot clean with water, a mild soap and a
sponge. Don't use abrasive cleaners or
brushes.
CLASSIC ACCESSORIES, INC.
KENT, WA USA 98032 ©2012
c l a s s i c a c c e s s o r i e s . c o m
do not line dry
use soap
do not iron water
resistant
do not
pack wet