Gardner Denver Thomas AP-30 Operación Manual página 6

Use a common blade screwdriver to push lower
portion of black switch lever over orange pin
so that the orange pin is no longer exposed.
Common blade
screw driver
Applicable LP & LW Series Diaphragm Switch Deactivation Instruction:
Note: The LP & LW Series models contain different switches. Identify what type switch your pump
has by comparing the various photos and instructions below:
D
isconnect power.
Remove housing screws and housing.
(4) Housing screws
Applicable LP & LW Series Diaphragm Switch Deactivation Instruction (Continued):
After positioning the diaphragm protection switch
to a vertical position with a common blade
screwdriver to deactivate switch, reassemble unit.
Diaphragm protective
switch activated.
(Pump will not run.)
Orange pin exposed
Diaphragm protection
switch activated.
(Pump will not run.)
LP Housing
Diaphragm protective
switch not activated.
(Normal operation mode.)
After positioning diaphragm protection
switch to proper position to deactivate
switch, reassemble unit.
After positioning diaphragm protection switch
lever to "ON" position to deactivate switch,
reassemble unit.
Diaphragam protection
switch acitvated.
(Pump will not run.)
Diaphragm protection
switch not activated.
(Normal operation mode.)
LW Housing
(6) Housing screws
Diaphragm protection
switch not activated.
(Normal operation mode.)
6