bredent bre.Lux PowerUnit 2 Manual De Instrucciones página 5

The display briefly shows „Red. Leistung (Red. power): off"
The light output is now at 100%; the materials are subjected to heat treatment and any residual
monomer content in the materials can be reduced.
If you want to cancel this mode, proceed as described and press the identical key combination.
Please press key
combination simultaneously!
" – " and „180s"
plus
Switch device on / ON !
The display briefly shows „Red. Leistung: ein (Red. power: on)"
The default setting of 50% is set again.
Programming of the 3 default programs F1 - F3 remains unchanged in the selected operating mode
(can therefore only be changed by switching over).
The device can be individually programmed in the free programs.
With reduced light output, the average temperature in the curing chamber is approx. 55°C during
continuous operation.
5