Publicidad
Idiomas disponibles
Idiomas disponibles
COMPUTER
START / STOP
Slide the computer onto the mounting bracket until it snaps
To start the unit, press the RIGHT button to turn on the display
firmly into position. Press the release button to take out the
and the wireless mounting system. To stop the unit, left unused
computer.
for over 5-6 minutes and then the computer will automatically
switch off to preserve batteries.
WHEEL SIZE INPUT
Press and hold LEFT and RIGHT buttons for 2 seconds or after
the replacement of battery, the unit is switched to wheel size
input mode. Multiply wheel diameter, d in millimeters by 3.1416
to determine wheel factor, c.
Press the LEFT button to select digit to be input and the RIGHT
button to adjust the digit to the desired number (hold for fast
advance). Press the LEFT button again to KM/MILE selection.
(Note: removing battery will erase Wheel Size Input)
For convenience you can refer to the chart of wheel diameter
size factor inputs.
Release
ATTENTION !! Refer to the appendix for installation reference.
KM / MILE SELECTION
After the wheel size input, the following function is selection of
kilometers or miles as the measurement for distance. Press the
RIGHT button to choose between kilometer (KM) and Mile (M),
press the LEFT button to confirm.
SPEED COMPARATOR
A "+" or "-" sign appears to the right of the
speed. "+" indicates you are travelling
faster than your average speed (AVS). A
"-" indicates you are riding slower than your
average speed.
SPEED TENDENCY
A cyclist symbol appears to the left of the
speed. The wheel turns forward
indicate acceleration.
backward
SPEEDOMETER (SPD)
Instantaneous Speed is indicated on the
top line. The range of measurement is
distance in millimeter
from 0 to 99 KM/ hr [0 to 99 M/ hr] and
per one turn
accuracy is ± 0.5 KM/ hr [M/ hr].
CLOCK
(12H / 24H)
A 12 or 24-hour digital clock is indicated by
the flickering colon on the bottom line. To
switch between the 12 and 24 hour format
or to adjust time, press the LEFT button for
2 seconds. "24H" will start to flicker. Use
the
RIGHT
button
(Cadence)
for12-hour format or "24H" for 24-hour
format. Press the LEFT button to confirm.
Next the hour digits will start to flicker. Use
the RIGHT button to select the hour. To
change minutes, press LEFT button again.
The minutes will start to flicker. Use the
RIGHT button to select the minutes. Press
the LEFT button once more to return to
CLOCK Mode. Press the RIGHT button to
enter ODO mode.
(Acceleration & Deceleration)
ODOMETER (ODO)
to
The wheel turns
Total distance travelled is indicated by
to indicate deceleration.
ODO and display on the bottom line. To
reset ODO, press and hold LEFT and
RIGHT buttons for 2 seconds or remove
the battery. Press the RIGHT button to
enter DST mode.
TRIPMETER (DST)
(Trip Information Reset Mode)
Trip distance measurement is indicated by
DST and is displayed on the bottom line.
Tripmeter is activated automatically with
speedometer input. Reset DST to zero by
to
select
"12H"
pressing the LEFT button for 2 seconds;
DST (Trip distance), TM (Trip Timer) & AVS
(Average Speed) will also be reset at that
time.
Press the RIGHT button to enter
MXS mode.
TRIP TIMER (TM)
Trip timer measurement is indicated by TM
and is displayed on the bottom line. Trip
Timer is activated automatically with
speedometer input [On when you ride and
off when you stop.] It records only the time
spent actually riding.
Reset TM to zero by pressing the LEFT
button for 2 seconds in DST mode. Press
the RIGHT button to enter Temperature
mode.
Publicidad
