GLÄSS ROPE Manual De Instrucciones página 12

EN
treated, not even with common varnish or paint, since it
ineffective and on the other would give rise to the risk of
Clean the sauna cabin with a wet cotton cloth and dry it with a
clean, dry cloth.
If the sauna remains unused for a long time, it is advisable to
the wood from absorbing moisture.
personnel.
only authorised technicians to avoid losing warranty rights. The
wrongly.
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
electrical installation technician.
- The switch is on.
In the event "E" followed by a NUMBER
the authorised assistance centre.
HANDLING
If it is necessary to move the sauna to another location,
even inside the same room, it must be dismantled and then
reassembled where required, once again following the assembly
instructions given in this manual.
we recommend washing them again before inserting them inside
the heat generator.
and the largest ones on the surface. The stones must not be
of the stove.
and any that are broken will be discarded.
This is done to ensure correct air circulation inside the stove and
to avoid overheating of the heating elements and consequent
CAUTION: lack of ventilation through the stones positioned
inside the stove can cause malfunction of the heating
elements.
WARNING FIRE HAZARD: do not pour essential oil
concentrates onto the stove without diluting it with lots of
water, APPROX. 3 DROPS FOR EVERY litre OF WATER. DO
NOT HEAT WITHOUT STONES.
FIRST TIME OF SWITCHING ON
installation.
switch.
SAUNA USER MANUAL".
at a time, remaining for shorter times at the beginning to avoid
After the sauna it is usual to take a cold shower to bring body
on the skin.
In order to use the sauna one must start the stove at least
before switching on.
WHEN USING THE SAUNA FOR THE FIRST FEW TIMES,
STEAM COULD CONDENSATE ON THE INTERNAL SURFACE
OF THE GLASS DUE TO THE MOISTURE IN THE WOOD. THIS
TEMPORARY EFFECT OF CONDENSATION WILL STOP IN
A VERY SHORT TIME.
12
STOVE
.
SAUNA
Make sure that there is no