How To Use The Adjustable Nozzle - SpeedClean 2200 PSI Instrucciones De Uso

How to Use the Adjustable Nozzle

You should now know how to START and STOP your
pressure washer.The information in this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1. Slide nozzle forward when you wish to adjust spray to
low pressure mode (Figure 13). Slide nozzle backward
to achieve high pressure.
Figure 13 — Adjusting Nozzle for Pressure
Forward = Low Pressure
and Detergent Mode
2. Point nozzle down towards a firm surface and press
trigger to test spray pattern (Figure 14).
Figure 14 — Testing the Spray Pattern
SpeedClean™ 2200 PSI Pressure Washer
Backward = High Pressure
Mode
3. Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 15).
Figure 15 — Adjusting the Nozzle for Spray Pattern
Clockwise = Narrow Spray
Pattern
Usage Tips
• For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
• If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
How to Use the Floor and Utility
Brushes
The floor and utility brushes allow you to scrub surfaces
with water filtering through the bristles.
To attach the utility brush to the gun:
1. Tighten the adapter to the brush base.
2. Remove the nozzle extension from the spray gun, if
attached.
3. Attach the brush with the adapter to the spray gun.
Tighten by hand (Figure 16).
Figure 16 - Attaching Utility Brush to Spray Gun
NOTE: You must use the adapter to attach the brush to
the spray gun.
To attach the floor brush to the gun:
1. Tighten the adapter to the brush extension.
2. Remove nozzle extension from spray gun, if attached.
3. Attach brush extension to spray gun.Tighten by hand.
4. Attach floor brush handle to floor brush.Tighten by
hand.
12
Counterclockwise = Fan
Spray Pattern