ASSEMBLY
IMPORTANT: Read entire operator's manual before you
attempt to assemble or operate your new pressure washer.
Unpack the Pressure Washer
1.
Remove everything from carton except pressure
washer.
2.
Open carton completely by cutting each corner from
top to bottom.
3.
Remove pressure washer from carton.
Carton Contents
Items in the carton include:
•
Main Unit
•
Handle
•
High Pressure Hose
•
Spray Gun
•
Adjustable Nozzle Extension
•
Utility Brush
•
Floor Brush
•
Brush Extension
•
Oil Bottle
•
Accessory Storage Bag
•
Cleaning Tank
•
Parts Bag (which includes the following):
•
Operator's Manual
•
Engine Operator's Manual
•
Owner's Registration Card
•
Floor Brush Handle
•
Brush Adapter
•
Safety Goggles
•
Handle/Cleaning Tank Fastening Hardware Kit
(which includes):
•
Carriage Bolts (2)
•
Plastic Knobs (4)
•
"L" Hooks (2)
•
Tree Clips (4)
SpeedClean™ 2200 PSI Pressure Washer
7
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115. If calling for
assistance, please have the model, revision, and serial
number from the data tag available.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1.
Fill out and send in registration card.
2.
Attach handle and cleaning tank to main unit.
3.
Connect detergent siphon hose to pump.
4.
Add oil to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect high pressure hose to spray gun and pump.
7.
Connect water supply to pump.
8.
Attach nozzle extension to spray gun.
Attach Handle and Cleaning Tank
1.
Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
Handle
Handle
Supports