Dynex DX-DA100501 Guia Del Usuario página 8

Dynex DX-DA100501 camcorder battery charger - combined.fm Page 8 Friday, October 28, 2005 2:54 PM
8
Mounting the battery into the charger
For use with Lithium-Ion (Li-ion) batteries
Warning:
charge Nickel Cadmium (Ni-Cd) or Nickel Metal Hydride (Ni-MH) batteries.
To mount the battery into the charger:
1 Note where the guides and contacts are located on the battery and align
them with the corresponding guides and contacts on the charger, then slide
the battery into place in the charging bay.
2 Press the battery down, then slide it up (away from the indicator lights).
- OR -
Slide the battery up, then press it down (depending on the battery to be
charged).
Do not force the battery onto the charger. If it does not slide easily into the
guides, re-align it and try again.
U
SING AN ADAPTER TRAY
Depending on your battery type, you may need to use an adapter tray. Refer to the
Battery Compatibility List to determine which adapter tray should be used with
your battery type.
To install the adapter tray onto the charger:
1 Slide the central notch on the adapter tray's upper edge into the slot on the
upper edge of the charger bay, then carefully press down on the lower edge
of the adapter tray.
The adapter tray snaps firmly in place. Install the battery so that its contacts
meet the contacts on the adapter tray.
2 To remove the adapter tray, pull back on the battery/adapter latch, then lift
the adapter tray up and out of the charger.
U
SING THE UNIVERSAL ADAPTER PLATE
The universal adapter plate label provides only a partial list of batteries that are
compatible with this charger plate. Refer to the Battery Compatibility List for the
entire make and model list of compatible batteries.
Using the charger
. attempt to
only Do not