Charging The Battery - Dynex DX-DA100501 Guia Del Usuario

Dynex DX-DA100501 camcorder battery charger - combined.fm Page 12 Friday, October 28, 2005 2:54 PM
12
Batteries
For the batteries in the box below, you need to flip up the Flip 1 mating battery contact
terminals found on the left side of charger plate.
SHARP: BT-L226
OPTEX: LI28

Charging the battery

Charging begins as soon as the battery is properly connected. The green charging
status indicator blinks as the battery is being charged. When the battery is fully
charged, the green charging status indicator stops blinking and stays on. You can
remove the battery for use when this happens, but we recommended that you
leave the battery on the charger for another 30 minutes to ensure a full (topped
off) charge.
A
UTOMATIC BATTERY VOLTAGE DETECTION AND INDICATION
Most camcorder and digital camera Lithium-Ion (Li-Ion) batteries are either 3.6 V
or 7.2 V. This charger has built-in battery detection for automatic selection of the
appropriate output voltage to the battery, to ensure safe and efficient charging.
The 3.6 V/7.2 V battery voltage indicator lights red when charging a 3.6 V battery,
and lights green if the battery is 7.2 V.
Using the charger
Position