Tronsmart Encore S2 Plus Manual Del Usuario página 4

FUNCTIONS
Power On
Power Off
Pairing mode
Play/Pause
Volume +/-
Previous/
Next track
Answering
a call
Rejecting a call
Ending a call
Redialing the
last called-out
number
Standby mode
Microphone
muting
Low battery
Hold the multifunction button for 2 seconds till the blue
indicator light goes on.
Hold the multifunction button for 4 seconds till the red
indicator light flashes 1 second and then goes off.
Note: The headphones will automatically turn off if there is no
connection with any device within 5 minutes.
1. First use: Turn on the headphones, the red and blue lights
will flash alternately. Scan 'Tronsmart Encore S2 Plus' on your
Bluetooth device and tap to pair.
2. Re-pair: Power on the headphones, it will re-pair the device
that you pair with last time.
3. Bluetooth disconnect: Press the 'V+' and 'V-' button
simultaneously to disconnect the Bluetooth.
Tap the multifunction button once to play or pause the song.
Tap 'V+' button to turn up the volume.
Tap 'V-' button to turn down the volume.
You will hear a voice prompt when it is at the maximum or
minimum volume level.
Previous track: Hold the 'V-' button for 1 second.
Next track: Hold the 'V+' button for 1 second.
Tap the multifunction button once to answer the call. Switch
the answering modes between Bluetooth and mobile phone
via holding the multifunction button for 1 second.
Hold the multifunction button for 1 second to reject the call.
Tap the multifunction button once.
Double tap the multifunction button to dial the last call-out
phone number.
Under pairing mode, if there is no device to pair with, the
headset will go to standby mode and power off after 5
minutes.
Hold the 'V-' button for 1 second to mute the microphone.
There is a voice prompt every 10 seconds. Hold the 'V-' for 1
second, it will work again.
There will be a voice prompt every 60s with the red light
flashes twice.
2