Install The Hardware - Axis P1365-E Guia De Instalacion

To create extra cable holes, open the drill-outs located below the holder. See Hardware Overview
on page 8.
NO TICE NO NO TICE TICE
Use cable gaskets or cable glands that match both the cable hole and the cable area.
For information about accessories, such as cable gaskets and cable glands that allow for other
cable areas, see www.axis.com

Install the Hardware

NO TICE NO NO TICE TICE
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required.
All cables connecting the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their specific use. Make sure that
the network devices are installed in accordance with the manufacturer's instructions.
For information about regulatory requirements, see Regulatory Information
• Be careful not to scratch, damage or leave fingerprints on the window because this could
decrease image quality.
The Axis product can be installed with the cables routed through or along the wall.
Read all the instructions before installing the product:
1. Install the wall mount. See Install the Wall Mount. For detailed instructions, see the wall
mount's Installation Guide, supplied in the package or available on www.axis.com
2. Attach the housing to the wall mount. See Attach the Housing to the Wall Mount.
3. Install the camera in the housing. See Install the Camera in the Housing.
Install the Wall Mount
CAUTION
Make sure that the screws and plugs are appropriate for the material (e.g. wood, metal,
drywall, stone) and that the material is strong enough to support the combined weight
of the camera, housing, and wall mount.
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable through the wall bracket. Leave approximately 30 cm (11.8 in) of
cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
AXIS P1365-E Network Camera
17