Care And Cleaning - LUND AVS Ventvisor Instrucciones De Instalación

Installation Steps
Gently press the exposed areas of tape against the surface and
verify position. With the Rear Visor in its final position, remove the
remaining tape liner by pulling on free ends.
8
6 Piece Set
Remove tape liner from front and rear flanges of Extended Rear
Visor. Peel back 2" (5cm) of tape liner from end of top flange.
free end
10
rear flange
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the re-
maining tape liner by pulling on free ends.
12

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms
of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
top flange
front flange
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Apply ressure along all flanges to ensure proper adhesion of tape.
9
Align the deflector on the outside of the door frame. Align the front
of the Extended rear Visor parallel to the previously installed Rear
11
Apply pressure along all flanges to ensure proper adhesion of tape.
13
Repeat Steps 1 - 13 for opposite side.
logo are trademarks of Lund International, Inc.
TM
Page 3 of 3
Visor.