Preparing A Hard Disk For Use With Windows 2000/Xp/Vista/7 - Ewent EW1015 Manual De Instrucciones

1. Double-click with the left mouse button the 'Safely remove hardware' icon in the
taskbar, near the clock.
2. Select the EW1015 (USB device for mass storage) and click 'Stop'.
3. Click 'OK' to confirm.
4. Disconnect the hard disk from the EW1015.
4.0 Preparing a hard disk for use with
Windows 2000/XP/Vista/7
When using a hard disk for the first time, you have to make the disk 'visible'. Use the
following steps to make the hard disk 'visible'.
1. Right click the 'My Computer' icon.
2. Click 'Manage'.
3. Select the option 'Disk Management' from the left side of the screen.
4. Right click the new hard disk and choose 'Initialise'.
5. Click 'Ok'.
6. Right click the new hard disk.
7. Click 'New Partition'.
8. Click 'Next'.
9. Click 'Next'.
10. Click 'Next'.
11. Choose the desired partition format (Note: when using FAT32 the partition size is
limited to 32GB).
12. Click 'Next'.
13. Select the drive letter you wish to assign to this partition (this is not required).
14. Click 'Next'.
15. Select the desired file system: FAT32 or NTFS.
Note! If you only use the hard disk on Windows XP, Vista or 7 systems we recommend
you to select the NTFS file system. If you're using Windows98(Se) of Windows ME,
choose FAT32.
16. Enter a name for the new partition in the field 'Volume label'
17. Enable the checkbox near 'Quick format'.
18. Click 'Next'.
19. Click 'Finish'.
20. The hard disk is now ready to be used.
5 |
ENGLISH