Operating Instructions; Starting/Stopping Instructions - Troy-Bilt TB24HT Manual Del Operador

Unit
Housing

STARTING/STOPPING INSTRUCTIONS

Your hedge trimmer is equipped with a safety switch,
that reduces the possibility of accidental starting. The
safety switch is located on the front handle (Fig 7).
You must press both the safety switch and trigger switch
in order to start the unit.
WARNING: Battery tools do not have to be
plugged in; they are always in operating
condition. Avoid unintentional starting,
never carry unit with a finger on the trigger.
8

OPERATING INSTRUCTIONS

Battery
Platform
Battery
Ridge
Fig. 5
Battery Latch
Fig. 6
Safety Switch
The trimmer will stop if you release either the trigger or
safety switch.
To start the unit:
1. Make sure the power cord is plugged in (TB24HT) or
the battery is securely inserted (TB24HTB).
2. With the blade facing away, hold the unit by the front
and rear handles (Fig. 8).
3. Start the unit in a position where the blades will not
bind with the hedge to be trimmed.
EXTENSION CORD RETAINER (TB24HT only)
There is an extension cord retainer to prevent the
extension cord from disconnecting during use. It is
located on the end of the power cord (Fig. 9).
To secure both cords, form a loop with the extension
cord and push it into the retainer clips.
Trigger Switch
Fig.7
Fig. 8
Cord Retainer
Clips
Fig. 9