Installing And Removing The Battery - Troy-Bilt TB24HT Manual Del Operador

7. After charging, disconnect the 14.4V charger from
the wall outlet and remove the battery from the
charging stand (Fig. 3).
Indicator Lights
The green light will come on to indicate that the charger
is receiving power. This light will illuminate when the
barrel connector is inserted into the charger and the
charger is plugged into a socket (Fig. 4).
When the red light is on, the battery is being charged.
If the light fails to turn on, check the following:
a. Barrel connector has been properly installed into the
charging stand.
b. 14.4V charger has been plugged into the wall outlet.
c. Battery is firmly seated in the charging stand.
d. Power is on at the wall outlet.
WARNING: To prevent serious personal
injury, if the wall outlet is not working
properly, have the wall outlet checked by a
qualified electrician.
NOTE: If the wall outlet is operated by a switch, be sure
the switch is ON.
Battery Charger
ASSEMBLY INSTRUCTIONS
Green Light:
Charger is
Powered
Red Light:
Battery is
Charging
Fig. 4
Charging Tips for Maximum Performance
• Store and charge the unit where temperatures are
between 50˚ F (10˚ C) and 100˚ F (38˚ C). Storing the
unit or batteries above 100˚ F (38˚ C) will reduce
battery life.
• Storage below 50˚ F (10˚ C) will not reduce battery
life, but may require a longer charging time.
NOTE: The charging indicator light will remain lit when
the battery is properly installed in the charging
stand.
Temperature Effects on Charging Time
• 50˚ F (10˚ C) to 100˚ F (38˚ C) – Battery will be
charged within 24 hours.
• 40˚ F (4 ˚C) to 50˚ F (10˚ C) – Battery will require up to
48 hours for a full charge.
• Below 40˚ F (4 ˚C) – Battery will not reach full charge.
NOTE: Unit run time will be reduced when the battery is
not fully charged.

INSTALLING AND REMOVING THE BATTERY

(TB24HTB only)
CAUTION: When placing a battery in your
unit, be sure the battery ridges slide in the
housing channel, and that the battery snaps
into place. Improper assembly can case
damage to internal
1. Align the ridges on both sides of the battery's center
platform with the channel on the rear of the unit
housing (Fig. 5).
2. Slide the battery along this channel until the battery
and latch snap into place. Make sure the battery is
secured in the unit before beginning operation.
To remove the battery, locate the latch on the end of the
battery. Hold the unit securely, then push down on the
latch with your thumb and slide out the battery (Fig. 6).
components.
7