Technical Information - TECshow STRATUS 400 Manual De Usuario

5. OPERATION
Using the Wired Remote
Trigger the Stratus 400 using the included wired
remote. The LED indicator on the remote indicated
when the fogger has reached the required operat-
ing temperature. Press the button on the remote to
mamentarily output fog. The length of the wired is
13 ft (4m).
• Fill the fog fluid reservoir with Ampro wa-
ter-based fog fluid before operating the Stratus
400.

6. TECHNICAL INFORMATION

Fogger Maintenance
Do not allow the fogger to become clogged. After
every 40 hours of continuous operation, use Am-
pro Fog Cleaner Quart (FCQ) through the system to
prevent the accumulation of particulate matter in
the heating element. The recommended cleaning
procedure is as follows.
1. Unplug the product from power.
2. Empty all fog fluid from the machine.
3. Add cleaning solution to the tank.
4. Connect the product to power and allow it to
warm up.
5. Run the unit in a well-ventilated area until the
tank is almost empty. Do not allow the pump to
run dry.
6. Refill with fogger fluid to continue using the
fogger. Run the machine briefly to clear any
remaining cleaning solution from the pump and
heater.
• Do Not operate the machine without fluid at any
time.
P. 8
Tecshow Stratus 400 |
English version
LED Indicator
Light
Momentary Fog
Button
Permanently Wired Remote
• Fog Cleaner Quart (FCQ) was specifically devel-
oped by Ampro to clean your Stratus 400. Make
sure you use FCQ regularly, no longer than 90
days between cleanings, to increase the life of
your product.
Storage
Before storing the fogger, run FCQ through the sys-
tem as described in the cleaning procedure above;
however, only follow steps 1 through 5. Do not refill
the tank with fog fluid if storing the fogger. Cleaning
the system prior to storage will help prevent any
particles from condensing inside the pump or heat-
er while not in use.
Test-run your Stratus 400 on a monthly basis to
achieve the best performance.