Tabla de contenido
Publicidad
Installation
Follow the steps to install the DisplayPort
4k monitor installation
Step 1: Connecting graphics splitter Thunderbolt
graphics source, such as a Desktop or Notebook PC Thunderbolt
output interface.
Step 2: Connecting graphics splitter DisplayPort
Maximum connection: 2 different types of DisplayPort
Step 3: Power on PC and monitors. Select monitors to correct input
source.
Step 4: Change the display to clone mode, change the output
display resolution on your computer.It is recommended to use the
same size, type and resolution monitors for connecting. Same type
monitor means the monitors have the same native resolution and dis-
play refresh rate. After installation, you will see the same image on
all monitors (clone mode) or a single image spread across multiple
monitors. To change the display setting, simply change the graphic
card output resolution via the display properties page.
NOTE:
Display resolution with 2 connected 4k monitors
up to 4096x2160@60 Hz /each
5k monitor installation
Step 1: Connect the integrated Thunderbolt 3 cable to the
Thunderbolt
™
Step 2: Connect a DisplayPort
the adapter's DisplayPort
DisplayPort
™
Step 3: Your computer will detect the newly connected 5k monitor
and interact with it as if it were connected directly to your compu-
ter's native video card.
NOTE:
Display resolution with 1 connected 5k monitor
up to 5120x2880@60 Hz
Manual IB-SPL1025-TB3
TB
3 enabled USB Type-C
™
input ports.
port on your computer.
™
cable (not included) to each of
™
output ports and to your 5K monitor's
DP
DP
graphics splitter.
™
3 cable to
™
output to monitor.
™
3
™
monitors.
™
Publicidad
Tabla de contenido
