Plantronics CA10 Manual De Usuario página 10

CA 10Gray2 Body.r2 12/12/01
STEP 1
SETUP
Connect the CA10 Amplifier to your telephone using the
illustrations on page ii.
Unplug the telephone handset from the jack on your telephone
base and insert into the Handset Jack
CA10 Base Unit.
Using the Short Cord provided, plug one end into the
28
CA10 Telephone Jack and the other end into your telephone's
27
handset jack.
Now connect the AC Adapter
23
into a wall outlet. The Power LED
connected, but the In-Use Indicator Light
Make sure you remove the shipping battery insulator pull tab
located between the Remote Unit and the Battery Pack. Attach
the Remote Unit to the Battery Pack. The Remote and Battery Pack
slip together easily and gently snap in place. Do not force.
Connect your headset to the Remote Unit Headset Jack
the Headset Cable into the Retainer
whose cable terminates in a Quick Disconnect
will need the QD to 2.5mm Headset Adapter Cable
43446-02).
Firmly slide the Remote Unit and Battery Pack into the Charging
Well until the Charge Indicator
19
6:50 PM Page 6
on the underside of the
26
to the AC Adapter Jack and
24
will light after
13
will remain off.
14
. Press
3
. If you are using a headset
6
™
(QD) module, you
(P/N
11
lights.
15
6
Note: Remote Unit must remain in the Base for 5 seconds to
establish a communications link before the system can function.
Prior to first use, the Battery must charge for 8 hours before the
Remote will operate away from the Base.
G
You may, however, use the Remote while it is in the Charging
Well. (Note: May increase charging time.) The Charge LED will
turn off after the Battery is fully charged.
You are now ready to make or receive calls.
A
B
C
7