General Safety Instructions; Installation And Use - Sicce Flower LED Basic Manual De Instrucciones

Dear Valued Customer,
EN
Thank you for choosing FLOWER LED light for outdoor and indoor use, ideal to
create beautiful atmospheres in gardens, ornamental ponds and everywhere a touch
of light is required.
FLOWER LED may be used both submersed and out of water, therefore this versatile light can be
used even inside your home. FLOWER LED is perfect to light up dark corners, creating delicate and
romantic atmospheres with its beam of light. The floating version of FLOWER LED, equipped with
pump and water feature, will be an original addition to your ornamental pond. FLOWER LED is 100%
made in Italy.
SAVE THESE INSTRUCTIONS

GENERAL SAFETY INSTRUCTIONS

FLOWER LED is made in conformity with the national and international security laws.
1) Check that the voltage on the label of the transformer corresponds to the voltage of the electricity
supply. The device must be powered by a differential switch which has a nominal current equal to or
lower than 30mA.
2) Before connecting the product to the electric network, check that the cable and the Flower Led light
are not damaged.
3) The Flower Led has a type Z cable link. The cable and the plug cannot be substituted or repaired; in
case of damage of them replace the entire product.
4) ATTENTION: do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning,
or if it has been dropped or damaged in any way.
5) The product can be used in water or in environment with a temperature not higher than 45 °C / 113 °F.
6) Do not use the light for uses different to those for which it has been designed.
7) Avoid to use the light with corrosive and abrasive liquids.
8) This product has not been designed for people with disabilities and/or children if they are not
supervised by a person responsible for their safety.
9) Extension cables and power distributors (e.g outlet strips) must be suitable for outdoor use.
10) Protect the plug connections from moisture.
11) Only plug the unit into a correctly fitted socket.
12) In case of problems that cannot be overcome, please contact an electrician or, when in doubt, the
manufacturer.
13) Never carry out technical modifications to the unit, the warranty would be void.
14) Keep the socket and power plug dry.
15) The power pack and the plug connectors of the power cables supplied are not water-tight, but only
rain and splash-proof. Do not route or fit in the water.

INSTALLATION AND USE

Plug the flower's cable into the transformer and tighten the ring nut.
Installation in water:
Position the transformer at least 2mt distant from the pond's perimeter. The flower should not be thrown
into the water but delicatly placed on the surface to assure proper floating. To anchor the flower in place
is it possible to tie a fishing wire to the hole (H) which is close to the flower's petals, (Pic. A). The wire's
lenght should be the same of the pond depth.
Installation out of water:
To avoid possible fire hazards, maintain a minimum safety distance of 50cm from flammable materials.
Do not cover the flower.
For version with support base included:
It is possible to screw the flower into a solid and heavy base, using the small support, so to take
advantage even of small spaces (Pic. 1).
When using the light out of water, we advise adding pebbles or gravel to the big support base, in order
to make the flower more stable. Thanks to the big support base, the light can be placed in any point of
your pond or garden (Pic. 2).
6