Remote Control - THOMSON WM40i Manual De Instrucciones

SAFETY RECOMMENDATIONS
• Disconnect the appliance from the power source:
- if it is not going to be used for a long time,
- if there is a thunderstorm,
- if it isn't working properly.
• If the cable is damaged, it must be replaced by the
manufacturer, the manufacturer's after-sales service
department or a similarly qualified person, in order to
avoid any danger.
INFORMATION ABOUT BATTERIES
• The appliance must be equipped with the appropriate
batteries in order to function properly.
• Only recommended batteries should be used.
• Polarity must be respected when inserting batteries.
• The batteries should be inserted in such a way as to
avoid any short circuit.
• Do not mix used and new batteries.
• Do not mix alkaline, standard (carbon-zinc) and
rechargeable (nickel-cadmium) batteries.
• Do not recharge or try to open the batteries. Do not
throw the batteries in the fire.
• Replace all batteries at the same time with identical
batteries.
• Remove the batteries when unused for a long time.
• If the liquid contained in the batteries comes in contact
with eyes or skin, wash the area immediately and
carefully with clear water and consult a doctor.
• Battery shall not be exposed to excessive heat such as
sunshine, fire or the like.
ATTENTION: Danger of explosion if batteries are not
inserted correctly.
ABOUT THE DISKS
Handling
Do not touch the playback side of disks.
Hold disks by the edges to avoid leaving
fingerprints on the surface.
Any dust, fingerprints or scratches may cause
a malfunction.
Never attach a label or sticky tape to the disk.
Storage
Put disks back in their case after playing them.
Never expose disks to direct sunlight or heat
sources. Never leave disks inside a car parked
in full sunlight.
Cleaning
Use a clean soft lint-free cloth to clean the disk,
working from the centre outwards in a straight
line. Do not use solvents such as petrol,
thinners, commercially available cleaners or
antistatic sprays for vinyl disks.
EN 12
WALL MOUNT MICRO SYSTEM
WM40i

REMOTE CONTROL

1
2
3
4
5
6
TUN-
7
8
SLEEP
9
1
4
7
10
Insertion (lithium battery)
Replacing the button battery
The battery usually lasts for about 1 year.
Replace the battery if the remote control does not operate
the appliance in normal use.
Button battery (lithium battery)
• Grip the battery compartment on the back of the
remote control, then pull the strip to lift the battery
holder up.
• Insert 1 CR.2025 3V lithium mini battery, taking care to
respect the polarity indicated.
• Close the battery compartment.
FUNC
VOL+
VOL-
/MENU
TUN+
PROG/MEM
C-ADJ
TIMER
2
3
5
6
8 9
0
EQ
20
19
18
17
16
15
14
13
12
11