Urrea Boroscopio Flexible Simple Manual De Usuario página 8

brand, due to changes in specifications or per-
formance improvement.
Inserting / Removing the Batteries
Turn the lock nut in a counter-clockwise to
loosen the screw and then open the battery
cover. (Figure 1 and 2)
Figura 1
To insert the batteries, slide in the direction
indicated by the + and - as indicated on the
inside. (Figure 3)
Close the battery cover and tighten the screw.
(Figure 4)
Figura 3
You must remove the protective cap from the
lens at the front of the insertion tube. Befo-
re using the camera cable must be connected
to the handheld. Make sure the socket in the
cable duct is correctly aligned with the plug
close to the handheld. Tighten the connectors
together and tighten the cap by turning the
clock hands. To unlock, just turn countercloc-
kwise to clockwise. Press
rescope, the power indicator lights up, shows
"Ready". The borescope can be operated after
the message disappears. To turn off, press the
power button again.
8
Figura 2
Figura 4
to turn the bo-
Increase or decrease brightness
Each press can lighten or darken the light sour-
ce by one level. Hold the button
adjust the brightness to the maximum level.
Zoom-in and mirror
this button multifunction key is, in many cases.
Zoom in
To start press once and release.
pressing this button, the image being taken
is 1.5 time zoom in on the screen, as shown
"ZOOM" on the screen.
Press again
standard size, and displays "Normal" on the
screen simultaneously.
Mirror
To keep changing modes
conds and release. At the beginning of the
function of mirror, the image is displayed
on the screen as a mirror. Press
conds, turn off mirroring, and "M" disap-
pears, the image becomes the default mode.
Against the dark when shooting a subject of
high brightness, the camera light level decrea-
ses automatically. Push button decrease the
brightness until "L1".
-
Glare: when shooting a subject of reflection is
the light level decreases.
Press the increased brightness
U s er's Manu al
E N G L I S H
continuously
+
button, the screen becomes
Press 3 se-
for 3 se-
until "R".
+