Chal-tec CS CAPITAL SPORTS Spinnado Pro 18 Manual Del Usuario página 18

EN
Step 3
Sliding the handle bar support post (54) into the front post on the main frame (1) and
align holes for your desired height, then tighten it properly by the adjusting knob (19).
Put the handle bar (53) into the hole of the handle bar support post (54), then adding
the curved block (50) first on the bolt which is welded on the handle bar (53) before
screwing on the L adjusting knob (51). Loosen the adjusting knob (51) and adjust the
handle bar to your desired position, then tighten it properly by the L adjusting knob
(51). Note: Do not exceed the mark „stop".
18