Safety Information; Troubleshooting - HAMPTON BAY 216590 Guía De Uso Y Mantenimiento

5
ATTACHING THE CHIME COVER
□ Attach the chime cover to the chime base by pressing the
cover firmly onto the base.

Safety Information

Electrical work must be in accordance with national and local wiring codes. Contact a
qualified electrician if you have any questions as to the suitability of the system or any doubts
about your ability to wire this correctly.
Specifications
Package Contents
Finished Product Dimensions
Doorbell Type
Number of Tunes
Number of Zones
Adjustable Volume

Troubleshooting

Problem
Chime does not sound when push button is pressed.
Push button is not controlling chime properly.
Warranty
WHAT IS COVERED
The Warrantor is pleased to extend this Warranty to you, the original consumer/end user ("Consumer") of the doorbell products and listed by model
number below ("Doorbell Product"). This Warranty is valid for any Doorbell Product used in standard residential applications, and may not be assigned or
transferred by you.
Only doorbell products with the following model numbers are covered by this Warranty: 216589, 216590, 216591, 216592, 216593, 216594, 216595,
216596, 216597, 216598, 216599, 216600, 216601, 216602, 216603, 216604 and 216605.
For a period of one (1) year from the date of purchase, Warrantor, at its sole option, will repair, replace or refund the purchase price for any Doorbell Product
used in a standard residential application that malfunctions due to factory defective parts or defective workmanship in the manufacture or assembly of the
Doorbell Product.
6
ADD DIODE TO PUSH BUTTON
IMPORTANT: DIODE REQUIRED FOR INSTALLATION.
This diode must be securely installed on the terminal screws
of the FRONT door push button.
□ Remove push button cover.
□ Wire in diode per diagram below.
□ Re-install push button.
Wired Door Chime, Mounting Hardware and Diode for push button wiring
5 in. Height x 8.5 in. Width x 1.75 in. Depth
Wired
3
2
Yes
Possible Cause
Power to chime is turned off.
Volume control knob is turned down. Verify that the volume control knob on the base is
Wires are not securely fastened to
the chime.
Transformer does not work.
Diode not installed in push button.
WARNING: Always turn off the main electric
supply before installing the transformer.
Solution
Turn on the power to the chime.
turned up.
Check the screw terminals on the chime base and
tighten screws if necessary.
Test the transformer with a voltage meter. If it
does not read the appropriate voltage, turn off
main power supply and replace the transformer.
Follow suggested wiring diagram to install diode
in push button.
Please contact 1-844-891-5662 for further assistance.
HOMEDEPOT.COM