Geneva Touring/S+ Manual Del Usuario página 16

Keep pressed the or
When using your TOURING/S+ for the first time, the radio needs to find available
radio stations in your region (a scan function). After a SCAN, the stations will be
automatically stored.
• Hold down the button until "SCAN" displays. The indication will blink for
a few seconds, then the display will confirm that the first station has been found.
"SCAN" is also needed after traveling to a new location that provides different
radio stations, or when you move the radio to a different room with a different
radio reception.
Presets
You can save six FM stations plus six DAB stations. To save a preset:
1. Select the station you want to save.
2. Long press until the display shows "PRESET 1" as blinking.
3. If you want to save using a different PRESET number, press
to select the desired number.
4. After, long press to save the station.
To recall a preset:
1. Short press . The display will show the first saved preset. If a saved
station is playing , the display will show the next saved preset.
2. If you want to recall a different station, press
16
buttons to scroll the stations list.
or
or
3. Wait two seconds and the unit will play the selected preset station.
Line-in
To connect a source device to your TOURING/S+, you need a stereo audio cable
with 3.5mm jack plug connector.
1. Connect the cable to the audio source device (headphone or line-out plug).
2. Connect the other end of the cable to the line-In socket on the back of the
TOURING/S+. The unit will automatically change mode to LINE IN.
3. By disconnecting the cable from TOURING/S+, the unit will return to the
previously selected mode.
Bluetooth
Mobile phones and computers with Bluetooth can connect to the TOURING/S+
and play music. The mobile phone or computer must support Bluetooth A2DP.
Initial set-up ("pairing"):
1. Press the key. The display will show "BLUE". Wait for 20 seconds until
the display shows "PAIRING" as blinking .
2. Select "settings" on your mobile phone. Select "General/Bluetooth". Turn on
Bluetooth. New Bluetooth devices are discovered automatically (on some devi-
ces you will need to press 'scan').
3. After a few seconds, "TOURING/S+" will appear.
4. Select "TOURING/S+". The mobile phone is now connecting ("pairing") to the
TOURING/S+.
5. If the mobile phone asks for a PIN, enter "0000" (four zeros).
6. You can now play music on your mobile phone and listen to it on the TOUR-