Air Supply; Getting Started - GYS 051829 Manual Del Usuario

AIR SUPPLY

Getting started:

The compressed air network must be perfectly purged and adapted to the tool's consumption. A filter-lubricator-
regulator unit must be installed at a maximum distance of 10m before the tool (except for tools designed for use
without lubrication). Its regulating pressure must be set at 7.5 bars and the oil flow at about 1 drop every 30 seconds
for 100L/mn airflow. Warning ! The air consumption of the tool must absolutely be superior to the minimum priming
airflow of the lubricator. A shut-off valve must be installed upstream.
The connection between the filter-lubricator-regulator unit and the tool must be made with a special air supply flexible
hose made of rubber or PVC, with a maximum length of 10m and a minimum inside diameter of 8 mm. It must be
equipped with a semi-automatic self-closing coupling close to the tool, in order to unplug it easily.
Use:
Exclusively use accessories in perfect condition and matching the specifications of the tool.
Disconnect the tool from air supply before changing the grinding discs. Check that the disc is perfectly tightened before
using the tool again.
Regularly check the air supply pipes. In case deteriorations or leaks are noticed, proceed to the repair immediately.
Broken pipes may cause serious injuries.
Maintenance:
Every day, before use, disconnect the tool from the air line and pour a few of suitable oil through the air intake.
Do not use
flammable or volatile liquids such as kerosene, diesel or petrol.
Regularly proceed to check the level of the lubricator, and to bleed the filter and pipes.
Ensure that the air supply fittings, air pipes and hoses, and accessories are in perfect condition.
Regularly bleed the pipes and the tank of the compressor.
Use only genuine spare parts to ensure the maintenance of the tool.
GYS will not be liable it the tool is modified and if general safety instructions regarding air tools are not observed.
quick connector
COMPOSITION
 1 plastic box
 1 chuck key
 10 abrasive discs 120
OPERATING INSTRUCTIONS
Ideal for stripping sheet metal.
The abrasive backing is of the "rolloc" type.
Filter-lubricator-regulator unit
 1 mini grinder
 10 abrasive discs 100
 10 abrasive discs 80
 1 adapter
 3 polishing discs
3/4