nedis WIFIPO10FWT Guia De Inicio Rapido página 7

2. Open the Nedis SmartLife app on your phone.
3. Create an account with your mobile phone number or your e-mail address
and tap Continue.
4. Enter the received verification code.
5. Create a password and tap Done.
6. Tap Add Home to create a SmartLife Home.
7. Set your location, choose the rooms you want to connect with and tap Done.
Installation of the product (image B + C)
1. Open the cover (A
2. Unscrew the casing screws (A
3. Take the two halves of the casing apart.
4
Make sure the power cable is not connected to an electricity supply before
connecting it to the product.
4. Cut away rings from the sealing cap (A
diameter of the power cable.
6
5. Slide A
over the power cable.
4 The maximum diameter of A
6. Insert the power cable into the cable hole (A
6
7. Push A into A
8. Use a small screwdriver or pin to open the holes of C
9. Connect the positive and negative wires of the power cable to C
10. Use a small screwdriver or pin to open the holes of C
11. Connect the ground wire of the power cable to C
12. If desired, attach the lower half of the casing to a wall.
13. Reassemble the product.
14. Connect the power cable to an electricity supply.
4 The installation can be tested by repeatedly pressing A
has been successfully connected, the product will switch on and off and
make a clicking noise.
Add the product to the SmartLife app
1. In the Nedis SmartLife app, tap + in the top right corner.
2. Under Add Manually, select Smart Plug.
3. Check if the indicator LED is blinking rapidly. If so, tap to confirm.
4
4. If A does not blink rapidly, press and hold A
again.
1
).
2
).
6
is 21 mm.
3
6
) until the hole matches the
3
).
2
1
1
.
7
for 5 seconds and check
7
.
2
.
7
. If the power cable