Mounting Instructions - Walser ZIPP-IT 2VS Instrucciones De Montaje

EN
1.) Safety informations
Correct initial fitting and securing of the seat cover on the vehicle are
essential to guarantee the safety of the user. When fitting the seat cover,
proceed as follows: May only be installed in the motor cars listed on the
packaging or the enclosed detailed Clix brochure.
a) Driver and passenger seats must be mounted in
the correct positions. These can be determined by
the "Airbag" marking on the seat cover. The marking
must appear on the outer side of the seat backrest
(see Fig. 1).
b) Head restraint insertion holes, backrest adjustment levers/wheels for
releasing backrests or armrests must not be hidden by the seat cover.
Proper openings must be made. Please observe the fitting instructions on
the previous pages.
c) Seat covers that have slipped must be repositioned. If this is no longer
possible due to excessive wear, the cover must be removed or replaced.
d) Do not interfere with the openings in the covers (i.e. do not cover, sew up
or carry out any repairs yourself).
This cover has been tested by the TÜV-Rheinland Group.
Caution: Incorrect fitting can prevent the seat airbag from infla-
ting correctly in the event of a collision.
2.) Care and disposal information
Hand wash • Do not bleach • Do not tumble dry • Do not iron • Do not dry
clean
The seat cover can be disposed of as normal household waste.
Dispose of packaging material in accordance with local regulations.
Keep the bags away from small children – danger of suffoca-
tion.
16

Mounting Instructions

For seat covers prior to installation in the car.
For motor cars only.
Fig. 1