Tabla de contenido
Publicidad
PROGRESS
PC2100, 2101, 2102, 2103, 2108, 2109, 2110, 2114, 2115
− 32 −
MAINTENANCE
REPLACING THE DUSTBAG
Always operate the cleaner with the dustbag installed.
If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely.
After removing the flexible hose, open the front cover (fig. 21).
Remove the support of the bag.
Remove the dustbag and insert a new one (fig. 22).
Close the cover by pressing down until it clicks (fig. 21).
Dustbag reference number Menalux T210.
Dustbag reference number Progress−P67 (PC2110).
Textile dustbag
Remove the textile bag from the holder (fig. 23).
Slide the plastic clip away from the bag to open and empty (fig. 23−24).
Replace the plastic clip ensuring that both sides of the bag are parallel (fig. 23).
Replace the bag into the holder (fig. 23).
Note: The bag may be washed in luke warm water and dried completely. It should not be washed in
washing machine (fig. 25).
Close the cover by pressing down until it clicks (fig. 21).
REPLACING THE FILTERS
The dustbag must be replaced if the window of the dustbag full indicator is completely red when the cleaner is
operating at maximum power and the nozzle is raised from the floor.
Filters should be replaced at least twice a year or when they become visibly soiled.
Always operate the cleaner with filters installed to avoid reduced suction.
Disconnect from electrical outlet before changing the filters.
Do not use a washing machine to rinse filters.
Pull dustbag upward and remove the motor protection filter with grill (fig. 27).
Remove the filter from the grill (fig. 28).
Rinse the filter under tap water and dry it completely (fig. 29).
Place the filter back into the grill and put it back into the cleaner (fig. 28).
Open the filter grill to remove the exhaust filter (fig. 30).
Take the filter out of the grill (fig. 31).
Rinse the filter under tap water and dry it completely (fig. 33).
Place the filter back into the grill (fig. 32).
Close the filter grill (fig. 30).
PROTECTING THE ENVIRONMENT
Attempt to recycle packaging material and old appliances.
The cardboard packaging can be placed in the waste paper collection.
Deposit the plastic bag made of polyethylene (PE) at the PE collection point for recycling.
Recycling the Appliance at the end of its life:
The plastic components all carry a material identification marking so that, like the other materials, they can
recycled at the end of the life of the appliance.
Please inquire with your local authority.
Blocked air flow and dirty filters:
The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt.
Disconnect from mains and allow the cleaner to cool for 20−30 minutes. Remove blockage and/or clean filters.
Restart the cleaner.
− 5 −
Publicidad
Tabla de contenido
