PALSON Iris Modo De Empleo página 10

GB
EXTRA STEAM BUTTON USE
Be sure there is water in the tank and that the temperature selector is set to steam.
1. Horizontal iron use:
Lift the iron and press the extra steam button. It may be necessary to press the button several times after
filling in order to activate it. The extra steam function can be used only when ironing at higher temperatures
(from ·· a ···/Max).
. Vertical iron use:
The extra steam function can also be used when the iron is in a vertical position with the goal of removing wrinkles
from hanging clothes, curtains, etc.
SPRAYER BUTTON USE
Whenever there is enough water in the tank, the sprayer button can be used at any ironing temperature switch
with steam or dry. Push the button several times to activate the pump while ironing.
DELIMING SYSTEM
The iron incorporates a permanent deliming system designed to reduce fouling and prolong its useful life.
SELF-CLEANING BUTTON USE
1. Using the self-cleaning function is important the first time the iron is used and afterwards at least once a month
with the goal of eliminating fouling, etc.
2. Fill the iron with water to the water tank <<MAX>> line.
3. Connect the plug to the wall outlet.
4. Adjust the temperature switch to maximum.
5. Let the iron heat up until the pilot light (7) turns off and turns on again (several times).
6. Keep the iron in a horizontal position above the washing niche.
7. Turn the steam selector to its position (
self-cleaning button pushed (Unlock and press the button repeatedly until steam comes out). Boiling water
and steam will go out through the bottom holes and will eliminate impurities and fouling (if any). If the iron
continues to have a large amount of impurities/fouling, repeat the process.
8. Move the iron forward and backwards while carrying out the process.
9. Release the self-cleaning button when the water is exhausted.
10. Put the iron in a vertical position. Then disconnect it from the wall outlet.
11. Dry the bottom carefully passing a towel or old rag over the iron to ensure that there is no water remaining.
1. Do not use chemical water softeners.
13. Do not store the iron until it has cooled completely.
ANTI-DRIP SYSTEM
As indicated in the section on temperature settings, steam ironing is only possible at higher temperatures or for
moderate steam ·· or ··· for mild steam and ···/Max for maximum steam. The possibility of dripping water from
the bottom exists in conventional steam irons if an extremely low temperature is selected. However, this iron adds
a new function: an anti-drip system that will make the iron automatically stop releasing steam at low temperatures.
When this occurs, a click will be heard. Then adjust the temperature switch to the recommended position. The iron
will release steam again as soon as the adequate temperature is reached.
DRY IRONING
The iron can be used as a dry iron even if there is water in the tank. Do not pour water in the tank if you have
thought of using the iron in dry mode for several hours.
1. Put the iron on the rest heel, then plug it in.
2. Turn the steam selector to position "0".
10
) and the temperature selector to MAX and then keep the