EN
Commissioning
The CONNECT ID is still in sleep mode during initial installa-
tion. To activate it, it has to be supplied with power. Connect
the supplied power cable to the CONNECT ID's charging
port and a power source. Fully charge the CONNECT ID
before using it for the first time. If you remove the power
cable from the CONNECT ID and the LEDs flash twice, the
CONNECT ID is fully charged. If the LEDs flash only once, the
CONNECT ID is not fully charged.
Note: Please remove the protective film on the upper side of
the acrylic glass before operation.
Technical data
Voltage: 5V
Charging current: max. 500 mA
Battery capacity: 2500 mAh
Signal units: acoustic and optical signal (LED)
Others: 6 individually configurable buttons with visual
feedback via LEDs
8