Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Fitting The Belt Clip; Switching On/Off - Parkside Performance PDSSAP 20-Li B2 Traducción Del Manual De Instrucciones Original

Inserting/removing the battery pack

Inserting the battery pack
♦ Set the rotation direction switch 2 to the middle
position (lock). Snap the battery pack 8 into
the handle.
Removing the battery pack
♦ Press the release button 9 and remove the
battery pack 8.

Checking the battery charge level

Press the battery charge level button w to
♦
check the charge level of the battery. The
status/remaining charge will be shown on
the battery display LED q as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting the belt clip

♦ Loosen the fixing screw
Phillips screwdriver (not supplied).
Hold the corresponding hole of the belt clip 3
♦
over that of the screw thread.
♦ Tighten the fixing screw
8
GB │ IE
■ │
using a standard
3a
.
3a
Switching on/off
Switching on
Press and hold the ON/OFF switch 7 to start
♦
the tool.
The LED work light 4 lights up when the ON/
OFF switch 7 is pressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
Release the ON/OFF switch 7 to switch off the
♦
appliance.
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button 6 to select
the required torque incrementally. The selected
torque is shown on the torque display 5.
♦ Pressing the ON/OFF switch 7 lightly yields a
low speed. Increasing the pressure increases
the speed/tightening torque.
♦ The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
► When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
► The integrated motor brake ensures rapid
stoppage.
ATTENTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
PDSSAP 20-Li B2