Replacing The Grinding Discs; Storage; Disposal; Troubleshooting - HOLZMANN MASCHINEN DSM150 Manual De Instrucciones

16.2.2 Replacing the Grinding discs

Before opening the cover, make sure that the machine is disconnected from the
power supply and secured against accidental start-up. If you have just used the
machine, wait a few minutes before opening it until the grinding wheel and machine
have cooled down.
Remove the red protection cover with a screwdriver.
Fix the grinding stone and loosen the fixing nut on the arbour. Remove the fixing nut and the
flange.
Remove the old grinding stone and install the new one, place the flange onto the stone and fix
it with the nut. Install the red protection cover back.
Let the machine now run in test mode for one minute and check the stone for any vibration,
out-of-balance run.
16.3

Storage

Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended environmental
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine on the other hand.
16.4

Disposal

Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer,
he is obliged in certain countries to dispose of your old machine properly.
17

TROUBLESHOOTING

Danger due to electrical voltage! Manipulating the machine with the power supply
up may result in serious injury or death. Before carrying out any troubleshooting
work, always disconnect the machine from the power supply and secure it against
unintentional recommissioning!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to solve the problem.
Fault
Machine cannot be switched
on
Poor grinding performance
HOLZMANN MASCHINEN GmbH
W A R N I N G
N O T I C E
W A R N I N G
Possible Cause
 Mains plug is not plugged in
 O -O -switch is defective
N FF
 Grinding disc is worn out
www.holzmann-maschinen.at
TROUBLESHOOTING
conditions!
Remedy
Plug in the mains plug

Contact the Customer Service

Center
Replace grinding disc

Dress grinding disc

DSM150, DSM175, DSM200, DSM250
25