Prolonged Disuse; Instructions For Cleaning; Reminders For Cleaning; Instructions For Maintenance - AFG GW 35 Serie Instalacion Uso Mantenimiento

THE AUTONOMY OF THE DECALCIFYER IS STRICTLY
DEPENDENT ON THE CHARACTERISTICS OF THE
SUPPLY WATER.
When the hardness of the water is more than 40°F it
is advisable not to use a machine with built-in water
softener; it is suitable to install a separate water
softener with a capacity not less 12 lt.

12. PROLONGED DISUSE

Before any prolonged disuse of the appliance,
proceed as follows:
- Clean the appliance thoroughly.
Rub stainless steel surfaces with a cloth soaked in
-
vaseline oil to create a protective film.
Close cocks or main switches ahead of the
-
appliances.
If the machine is left unused for extended periods,
drain the water from the boiler and the electric pump
-
and apply some Vaseline on the stainless steel
surfaces.
Following prolonged disuse, proceed as follows:
Inspect the appliance thoroughly before using it
-
again.
Allow electric appliances to operate at the lowest
-
temperature for at least 60 minutes.

INSTRUCTIONS FOR CLEANING

IV.

13. REMINDERS FOR CLEANING

READ THIS MANUAL CAREFULLY. IT
PROVIDES IMPORTANT INFORMATION
FOR SAFE INSTALLATION, USE AND
MAINTENANCE OF THE APPLIANCE.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
Clean the satin finish stainless steel exterior surfaces,
the cooking wells and the surface of the hotplates
every day.
At least twice a year, have an authorized technician
clean the internal parts of the appliance.
Do not use corrosive products to clean the floor
beneath the appliance.
Do not use direct or high pressure water jets to clean
the appliance.
SATIN FINISH STAINLESS STEEL SURFACES
Clean the surfaces with a cloth or sponge using water
and proprietary non-abrasive detergents. Follow the
direction of the satin finish lines. Rinse repeatedly
and dry thoroughly.
Do not use pan scourers or other iron items.
Do not use chemical products containing chlorine.
Do not use sharp objects which might scratch and
damage the surfaces.
TANK
Remove the overflow from the drain hole. When the
tub is completely drained, carefully clean the bottom,
removing any uneaten food or any solids.
Only after you have done this operation, remove the
filter carefully in order to prevent food debris,
entangled in the mesh of the filter, fall into the
suction port of the pump.
Clean the wells by bringing the water to the boil, with
the addition of grease remover detergent if
necessary.
Remove any limescale deposits with a proprietary
limescale remover.
Remove and clean racks, overflow, and filter.
Remove and clean the wash and rinse arms and
nozzles.
INSTRUCTIONS FOR
V.
MAINTENANCE
14. REMINDERS FOR THE MAINTENANCE
TECHNICIAN
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
BEFORE DOING ANY MAINTENANCE,
COMPLETELY DRAIN OUT ALL WATER,
SHUT OFF THE POWER SUPPLY AND
CLOSE THE WATER SUPPLY COCK.
DO NOT USE WATER UNDER PRESSURE -
IT CAN DAMAGE THE ELECTRICAL
EQUIPMENT.
Only wash the body panelling when it is cold, using
only product specifically designed for steel.
If there is a risk of ice forming, drain the water from
22