Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting Receivers
Single Antenna Distribution Setup
1. Using Shure low-loss, 50 Ω coaxial cables, connect the right and left (channels 1 through 4, A and B) RF output ports on the
UA845UWB to the corresponding left and right antenna inputs on each receiver. Use the cascade ports to connect a fifth receiver.
2. Using the supplied power cable, connect the UA845UWB to a power outlet.
3. To daisy-chain receivers together with power output cables, connect the power output connector of the UA845UWB to the power in-
put connector of one receiver. Connect the remaining receivers similarly. Connect the power input of the unit to a power supply.
Note: No more than five Shure receivers should be powered through a daisy-chain from a single UA845UWB.
AC
Multiple Antenna Distribution Setup
1. Connect the cascade ports for RF output channels A and B of one UA845UWB to the an-
tenna input, channels A and B, of a receiver or second UA845UWB.
2. If desired, connect additional units in the same manner.
3. To daisy-chain receivers with power output cables, connect the power output connector of the UA845UWB to the power input con-
nector of one receiver. Connect the remaining receivers similarly. Connect the power input of the unit to an AC power source.
Warning: When adding additional UA845UWBs to a system, each UA845UWB should be connected to a separate power supply. No more than five
receivers can be powered from a single UA845UWB. Daisy-chaining multiple UA845UWB's through the power output ports will overload a single power
supply, possibly causing damage to the equipment.
6
ANTENNA B IN
input:
output:
Single UA845UWB Setup
input:
output:
Multiple UA845UWB Setup
RF OUTPUT B
input:
output:
Publicidad
Tabla de contenido
