Guarantee - Dometic MagicWatch MWE9004 Instrucciones De Montaje Y De Uso

MagicWatch MWE9004, 9008
A long tone sounds (approx. 3 seconds) after switching on the ignition
One or more sensors are defective or no longer connected to the control
electronics. The control electronics display shows the defective sensor:
• for example E1 for the front sensor with short cable or E4 for the front sensor with
long cable.
➤ Check the plugs and make sure they lock into place.
➤ Replace the defective sensor(s).
A
NOTICE!
The system does not work if one or more sensors are defective.
Device indicates obstacles incorrectly.
False alarms may have the following causes:
• For example dirt or frost on the sensors
➤ Clean the sensors.
• The sensors were incorrectly installed.
➤ Adjust the position or height of the sensors (fig. 3).
• The sensors have contact with the chassis.
➤ Disconnect the sensors from the chassis.
Objects on the vehicle (e. g. spare wheel) lead to false alarms.
➤ Set parameter 10 to 1, so that fixed objects are no longer displayed (see chapter
"Setting the system" on page 12).
13

Guarantee

The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see the back of the instruction manual for the
addresses) or your retailer.
For repair and guarantee processing, please send the following items:
• Defect components
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
EN
Guarantee
15