Safety And Installation Instructions - Dometic MagicWatch MWE9004 Instrucciones De Montaje Y De Uso

Safety and installation instructions

1 Safety and installation instructions
The following texts only complete the figures on the supplementary sheet.
They do not contain the full installation and operating instructions. Please
observe the figures on the supplementary sheet.
Please observe the prescribed safety instructions and stipulations from the
vehicle manufacturer and service workshops.
Observe the applicable legal regulations.
The manufacturer accepts no liability for damage in the following cases:
• Damage to the product resulting from mechanical influences and excess voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
!
CAUTION!
• Secure the parts of the parking aid installed in the vehicle in such a way
that they cannot become loose under any circumstances (sudden
braking, accidents) and cause injuries to the occupants of the
vehicle.
• Do not fit the parts of the parking aid installed where an airbag may
open. This could cause injury if the airbag opens.
• The parking aid is intended as an additional aid, which means it does
not relieve you of the obligation to take due care when manoeuvring.
A
NOTICE!
• Installing the parking aid can cause problems on vehicles with LED tail
lights.
• If you would like to install the sensors on metal bumpers, you require
suitable adapters (not included in the scope of delivery).
• Do not expose the control electronics to dampness.
• The sensors may not cover signal lamps.
• When fitting the sensors, make sure there are no objects fixed to the
vehicle that are in the detection range of the sensors.
• Apply a small amount of grease inside the sensor plug connections.
4
MagicWatch MWE9004, 9008
EN