EFI ES-3000 Guia De Instalacion página 2

Callout Refers to
1 Targeting base
2 USB cable
3 Calibration plaque 8
4 Display holder
5 Status LED
Status indicator lights
The ES-3000 is equipped with lights that indicate device status. When the instrument is used with Fiery software, the
lights have the following behavior.
Lights Status
Off The ES-3000 is not connected to your computer or the software is not running.
Solid white The ES-3000 is connected but needs an initial calibration or the instrument calibration failed.
White, blinking The ES-3000 is ready to take measurements.
Blinks green once Start measurement.
Blinks green twice The measurement was successful.
Blinks red twice A calibration error or measurement error occurred.
Callout Refers to
6 ES-3000 instrument
7 USB port
Measurement button
9 Ruler
10 White backer
Setup Guide
EFI ES-3000 Spectrophotometer
2