Kübler CODIX 555 Manual Del Usuario página 45

5 5 . . 2 2 . . 4 4 C C h h a a n n g g i i n n g g t t h h e e S S c c a a l l i i n n g g S S l l o o p p e e
Menu <–> Selection
press the key to accept the selection
5 5 . . 3 3 S S e e t t t t i i n n g g t t h h e e S S c c a a l l i i n n g g S S l l o o p p e e
At least two points (2 pairs of value) for the
starting and the end points respectively of
the characteristic curve are reqquiered.
The curve can be ascending or descend-
ing.
At least two points (2 pairs of values) are
required for the start point and end point of
the scaling slope. This slope can be rising
or falling. A maximum of 24 scaling points
can be used.
I I n n p p u u t t r r a a n n g g e e 0 0 . . . . . . 1 1 0 0 V V , , 2 2 . . . . . . 1 1 0 0 V V , , 0 0 . . . . . . 2 2 0 0 m m A A , , 4 4 . . . . . . 2 2 0 0 m m A A
www.kuebler.com
Example: Yes
use the scaling slope curve,
Enter or alter scaling slope curve
H H o o w w e e v v e e r r i i t t s s h h o o u u l l d d b b e e n n o o t t e e d d t t h h a a t t i i n n a a l l l l
c c a a s s e e s s , , w w h h e e t t h h e e r r t t h h e e s s l l o o p p e e r r i i s s e e s s o o r r f f a a l l l l s s , , t t h h e e
v v a a l l u u e e s s t t h h a a t t a a r r e e i i n n p p u u t t t t e e d d ( ( I I n n p p . . 0 0 1 1 ... ... I I n n P P . . 2 2 4 4 ) )
m m u u s s t t i i n n c c r r e e a a s s e e s s e e q q u u e e n n t t i i a a l l l l y y . .
The scaling slope must lie within the limits
of the input and display ranges. The first
and last points can lie on the limits.
➱
Chapter 5.4, 15
➱
Chapter 5.3,
Display range
13
Page 13