Kübler CODIX 555 Manual Del Usuario página 63

6 6 . . 4 4 R R e e s s e e t t t t i i n n g g t t h h e e T T o o t t a a l l i i z z e e r r
Resetting is possible only if the MP input
has been programmed for the Reset
function.
Depending on the setting, the resetting is
carried out either manually with the red
key, and /or electrically with a high pulse
( > 4V; > 5 ms)at the reset input.
6 6 . . 5 5 D D i i s s p p l l a a y y H H o o l l d d
The Display Hold function is only available
for use with the current measured value
and for the totalizer value.
For as long as a high level signal
( > 4 V DC ) is present at the MP input,
The Display Hold function is only active with
the following parameter settings:
Reset totalizer value
And
Alarms
Reset totalizer value
And
Alarms
Output Mode
Reset totalaizer value
And
Alarms
Output Mode
Reset-Alarm-Latch
www.kuebler.com
R R e e s s e e t t : :
• Ensure the totalizer value is shown in the
display
• Press the red key and/or apply a high-
level pulse at the MP input
• The value in the totalizer will be cleared
then the display is "frozen".
The MIN/MAX capture, alarm monitoring
and totalizer functions continue in the
background.
Parameter
/
/
/
/
/
/
Settings
or
or
or
Page 31